ENME 414 Computer Aided Design
Homework B
Due Thursday, December 5, 1996

You are given two parts. One is a gear and the other is a shaft.
The geometry of these two parts are given to you. The gear has 20 teeth on it.
You are asked to assemble these two parts together.

Do the following three tasks using PRO/ENGINEER:

1. Make two component drawings, called Part 1 and Part 2. All the dimensions and tolerancing requirements should be indicated.

2. Assemble Part 1 and Part 2 and create a drawing called Assembly.

3. Using X-Section to obtain a sectional view of the assembly. Pay special attention to the hatch requirement.